Frequently Asked Questions
Find out all the technical specifications and diagrams for each of our products
Voltage Converters
A: Yes, the power rating shown in Amps is the continuous rating. We also show the Peak
rating in the Product Specification
A: Our Voltage Converters work from – 40 Deg.C TO + 70 Deg.C
A: We can mount our Voltage Converters in an IP66 rated Metal Enclosure which will allow
you to use them outside the Vehicle
A: Yes, our Voltage Converters have been designed using a building block system to
obtain the power needed to suit your requirements. You can buy larger Models directly
from us or can add to existing Units you’ve already purchased by wiring additional
Converters in parallel – For example 2 X E622 10A 12V to 24V Voltage Converters can be
wired in parallel to make 1 X E746 20A 12V to 24V Voltage Converter
Battery Chargers
A: Our Battery Chargers are most suited to Lead Acid, Gel or AGM Batteries. They will work
with LiFePO4 Batteries, however they may not fully charge a LiFePO4 Battery (which need
a slightly higher output voltage). Most Customers find that LiFePO4 batteries keep their
charge so well, they never need full charge (unless the battery is run right down)
A: Yes, our Battery Chargers have been designed using a building block system to obtain
the power needed to suit your requirements. You can buy larger Models directly from us
or can add to existing Units you’ve already purchased by wiring additional Battery
Chargers in parallel – For example 2 X E911 10A 12V to 24V Battery Chargers can be wired
in parallel to make 1 X E912 20A 12V to 24V Battery Charger
A: We can mount our Battery Chargers in an IP66 rated Metal Enclosure which will allow
you to use them outside the Vehicle
A: Yes, all our standard Battery Chargers are supplied with a “Control” Lead / Terminal
which allow you to turn the Charger on / off manually if required. Some Models offer an
automatic Turn On Voltage
Hazard Flashers
A: Yes, you can contact us to check on a suitable equivalent or visit our other website for
a list of the most common cross reference numbers
https://www.eurogroupgb.com//eurogroup_hazard_flasher_interrupter_cross_reference.html
A: No, our Hazard Flashers are designed for use with traditional Filament Bulbs and are
not suitable for LED Bulbs without fitting additional Load Resistors.
A: Our Hazard Flashers are “Relay” Flashers, not Electronic.
A: Our Hazard Flashers are fitted with 6.3mm Male Blade Terminals. These connect to a
standard 8 Way 6.3mm Female Faston Connector – we can supply these if required.
Speed Switches
A: Our Speed Switches are fitted with 6.3mm Male Blade Terminals. These connect to a
standard 8 Way 6.3mm Female Faston Connector – we can supply these if required
A: Yes, the Speed Switches are factory set to the speed requested. However, the user can
re-set the switch on / off speed by removing the side plug and re-setting the dip switch
accordingly.
A: The Speed Switch detects pulses from the Tachograph. The setting table assumes 4
pulses per metre to calculate road speed
A: Model E1047 turns equipment Off at the required speed. Model E1048 turns
equipment On at the required speed
Proudly British
All our voltage converters and chargers are proudly made in the UK, ensuring top quality and reliability. By keeping production local, we support the British economy, maintain strict quality control, and minimize our environmental footprint. Trust our UK-made solutions for exceptional performance across transport, marine, industrial, communications, and automotive industries.